Electronics Forum | Fri Aug 24 00:01:23 EDT 2018 | leeg
Have you tried to re-load the MINT software 1st? Are the breakers in at the back of the machine?
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Tue Mar 22 13:00:37 EDT 2022 | bukas
hi, I have a 265GSX machine that prints firs PCB in batch correctly and then missprints the rest(there may be acceptable prints by accident). after hitting END RUN and RUN again, first PCB comes out perfect but others are bad. paste is randomly shift
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Thu Dec 08 19:10:11 EST 2005 | Robert
Alan, I got that message before it come to the main screen so i could not reinstall the Mint program. Regards
Electronics Forum | Mon Feb 02 13:14:11 EST 2004 | kauer
Hey, going to lunch now. Just for kicks, did you try to re-load Mint files? They may have been lost some other way, I have seen the DEK software do some crazy stuff in the past. Talk to You in a bit.
Electronics Forum | Wed Dec 07 22:39:03 EST 2005 | Alan
Robert, you will have to re-load the MINT software. It only takes a couple of minutes to do this. This will fix out the errors. Refer to your DEK manuals on how to carry out this function. Cheers, Alan.
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
.gif)
winsouce.jpg)