Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Jun 03 18:49:32 EDT 2008 | edgetech
Hey, Does anyone have a calibration procedure for this machine. Thanks!
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Sat Mar 27 23:03:21 EDT 2010 | dman97
Well I'll be damned! I was printing this on the fiducial side. Silly me. I should have read the manual closer. Thanks for the help.
Electronics Forum | Sat Mar 27 23:44:16 EDT 2010 | dekhead
You were doing it right... for a 288. 3rd or 4th time in the last year or so I've had somebody do that. Glad I could help. http://www.dekhead.com
