Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Tue Mar 02 12:50:12 EST 2021 | ttheis
I have a parts 265 horizon if you want it. Was told it needs a front rail sensor but lmk if you are interested. Will sell cheap, located in milwaukee area.
Electronics Forum | Mon Jan 07 19:05:30 EST 2008 | ktroym
Thanks for all the help. The team on first shift reloaded the software and the machine is now running. Thanks once again.
Electronics Forum | Fri Jan 04 15:11:40 EST 2008 | bigdaddysoy9
Try reloading the software ya jack leg.
Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead
Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?
Electronics Forum | Thu Feb 21 19:30:32 EST 2019 | Seth
It won’t pass down regardless
