Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Fri Aug 12 18:39:21 EDT 2022 | magsat
Hello, please help, On DEK 265 GSX I have on the monitor: "Downloading vision system" and then nothing happens (no error comes up)
Electronics Forum | Sat Jul 20 07:40:51 EDT 2019 | kylehunter
I have a 265 horizon. I've noticed that if we wait more than a minute or so after that screen appears, it does the same thing you describe. It's like it goes to sleep and doesn't register the button. So maybe try watching the screen, and right as you
Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Sun Dec 23 00:11:43 EST 2007 | ktroym
When I try to bootup the machine I am getting an error that reads Dumping physical memory and a bunch of numbers & letters on the screen. The machine runs windows NT. Has anyone else had a problem like this before.
