Electronics Forum | Fri Jan 05 11:20:31 EST 2018 | dekhead
AC2 on MUX card).
Electronics Forum | Fri Jan 05 12:18:10 EST 2018 | dekhead
Does it happen in board stop move in diagnostics?
Electronics Forum | Fri Jan 05 14:58:36 EST 2018 | dekhead
Information sent to your email.
Electronics Forum | Fri Jan 05 03:32:46 EST 2018 | raymccomb
yes we resolved the engineer did not set the servo to zero so it did not know its datum start point.
Electronics Forum | Thu Jan 04 21:38:27 EST 2018 | dekhead
Error is occurring during move to fiducial 1 position (from board stop position)? Or during move to board stop position (from park position)? What is error displaying onscreen? Did you also just replace belt(s)?
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
winsouce.jpg)
