Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Thu Sep 29 03:40:43 EDT 2005 | aj
I have over 6 years experience working on Dek Printers, and I would highly recommend them to anyone BUT I have never seen the 2D Inspection last any longer than a couple of weeks running on the machine. This is the one side of things that they FAIL.
Electronics Forum | Sat Aug 24 08:01:28 EDT 2002 | kumarraju
Hi CS Tan, Most customers expecially tend to neglet maintenance of the machine. As in the case of Dek 288 most of the end users have the impression that the 288 is one of the worst machines by Dek. But till today although Dek has discountinued manufa
Electronics Forum | Tue Jun 18 08:47:50 EDT 2013 | wolverine
We recently had one of our older machines ( DEK 265GSX built in 1996 ) begin to have a problem of shutting itself down without warning, after checking out whatever I knew to try and find the cause, I pulled out the Y3 enclosure and removed all the ca
Electronics Forum | Wed Oct 13 03:38:21 EDT 1999 | Paul Gerits
Hi Morris, I work as a technical consultant, application specialist for Philips EMT (SMT machine suplier). For cost per placement complex calculation can be made. To make a easy one just to hav an idea you can use following. Information needed: Pr
1 |