Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Wed Nov 21 09:10:11 EST 2018 | dekhead
Are you seeing the stencil operational (changing state) in diagnostics? If sensor works then, look at image justification in product file...
Electronics Forum | Mon Feb 02 13:14:11 EST 2004 | kauer
Hey, going to lunch now. Just for kicks, did you try to re-load Mint files? They may have been lost some other way, I have seen the DEK software do some crazy stuff in the past. Talk to You in a bit.
Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Mon Jan 20 17:37:30 EST 2020 | sumote
Here is a picture of the inside of my machine. https://drive.google.com/file/d/1hsLLHz1ho867qcSf7AYUoivUUn8NFbH6/view?usp=sharing
Electronics Forum | Thu Sep 22 20:52:08 EDT 2011 | dekhead
Low DCV on batteries should not cause issue with MINT download, but will cause loss of MINT files (and necessitate reload) upon power down... Please contact me for additional assistance. http://www.dekhead.com
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Tue Jul 30 23:54:54 EDT 2019 | rob1
Is possible to view and edit PR1 files from a DEK 265 Horizon on a PC?
Electronics Forum | Sat Feb 25 11:23:58 EST 2006 | Curt
You may need to re-load the MINT files.
