Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Wed Apr 30 07:39:29 EDT 2008 | realchunks
Is the green box on top of the transformer? If so you can by-pass it.
Electronics Forum | Wed Apr 30 08:03:25 EDT 2008 | chineechooze
You need switch out the cognex vision card.
Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Wed Apr 30 07:45:05 EDT 2008 | gemengr
Yes, it is. there's a heat sensor under of 4 resister,look like it open now.I'm thinking to make a jumper right there to see it can power up the machine.(this's a little green box on top of the transformer)
