Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Thu Oct 26 15:44:28 EDT 2017 | dekhead
Sounds like you need to go into set-up and define HDD. Does not auto-detect.
Electronics Forum | Fri Oct 27 10:43:08 EDT 2017 | sumote
i believe someone has left a floppy disk in the drive. eject it and reboot.
Electronics Forum | Fri Oct 27 12:00:44 EDT 2017 | dekhead
That would give "ABORT, RETRY, FAIL" message.
Electronics Forum | Fri Oct 27 15:22:29 EDT 2017 | sumote
I defer to your superior knowledge John.
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
