Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Mon May 05 15:52:22 EDT 2008 | dekhead
Assuming you have the scale that corresponds with Board Width for center justified stencil. Formula would be: 2 x (distance to image {mm} - 368) = Board Width (setting on scale) http://www.dekhead.com/
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Tue Mar 02 12:50:12 EST 2021 | ttheis
I have a parts 265 horizon if you want it. Was told it needs a front rail sensor but lmk if you are interested. Will sell cheap, located in milwaukee area.
Electronics Forum | Wed Dec 19 12:31:14 EST 2012 | emeto
1. Check for pins or something else under the rails. 2. Check the motor for the axis and the sensor that defines up position(I doubt it there is an encoder for this motor) 3. check card 4. check interface cable
Electronics Forum | Fri Feb 14 08:08:45 EST 2003 | Louis
First of all I would like to say that my English is so-so but I will try to help you. FOLLOW THOSE STEPS AND YOU WILL BE OK. 1-- select learn fiducial option then enter minimal value to fiducial width and height (enter 0 and you will g
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Fri Jun 04 04:10:52 EDT 2010 | leeg
Have you checked the Rail Lifted Sensor
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
winsouce.jpg)
.gif)
