Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Sun Dec 23 00:11:43 EST 2007 | ktroym
When I try to bootup the machine I am getting an error that reads Dumping physical memory and a bunch of numbers & letters on the screen. The machine runs windows NT. Has anyone else had a problem like this before.
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Wed Nov 06 06:34:26 EST 2019 | kylehunter
We have a DEK HORIZON 265 that seems to be having an issue with the pressure setting for the squeeges. It seems to have an override making the set point of the squeege pressure always be 5kg. I have it set to 12kg, but on the first print, it errors
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Sat Sep 16 12:49:36 EDT 2006 | magszoo
I'm hoping that someone may be able to shed some light on this error we've been getting on our DEK 265LT printer. Several months ago we began getting a "Rising table position error" after the operator would open the hood to load paste or after changi
| 1 |
