Electronics Forum | Tue Feb 03 11:02:13 EST 2015 | dekhead
"DEK 265" can mean many things; need to be clear on what machine type. www.dekhead.com
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Tue May 09 08:46:43 EDT 2006 | eyryren
This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM
Electronics Forum | Thu Nov 01 16:02:26 EDT 2018 | ppatel1212
I'm not much familiar with DEK. Once i turn ON machine it will keep rebooting itself over and over. I need to find local service provider for DEK. if any know please try contact me we are located in N.Attleboro, MA .
Electronics Forum | Thu Nov 03 18:20:15 EST 2005 | JG
Dek 265 GS Problem: Machine abruptly turns off. It can be in the middle of a stroke or just sitting idle. After the machine turns off we have to let it sit for a few minutes (sometimes 20) in order for it to restart. Any suggestions? Thanks in adv
Electronics Forum | Wed Jan 06 15:25:35 EST 2010 | wolverine
Any help would be appreciated We have a DEK 265 Screener that has been showing symtoms of a bad power supply. Is there a way to back up the hard drive and is an executive program needed in case the machine totally dies. Dave
Electronics Forum | Fri Nov 04 07:20:27 EST 2005 | chunks
By-pass the surge protector on top of the power supply. Located at the bottom of the machine. Pretty common on older 265s.
Electronics Forum | Wed Feb 03 22:25:23 EST 2010 | mika
This works. I've tried and used it on several machines!
Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
.gif)