Electronics Forum | Thu Jan 07 13:52:28 EST 2010 | empac
Hi, I am looking for the following: Y actuator and P/N : 140377 for DEK265LT. Let me know if you have this part available. Thanks. Bob
Electronics Forum | Thu Oct 10 03:18:28 EDT 2019 | bukas
Hey guys, my DEK265 GSX is acting funny. It misprints half of the boards. The one half when squeegees move away from operator to be precise. When squeegees are moving towards operator print is perfect. In both cases actuators are moving prior to prin
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Sat Oct 21 03:02:02 EDT 2006 | aj
All, We had a power cut the today. Machine times out on Actuators and Paste Dispenser hence it will not Initialise fully. I have traced back each related card but all seem to check out fine. Next step is PSU (looks awkward to access) Any ideas fe
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Fri Aug 03 12:13:59 EDT 2001 | hinerman
T.A. board lok is fixed tooling. I have not used it, and therefore cannot comment on it. Their website describes it in detail for those interested. -The Grid-Lok system is completely pnuematic -Each pin locks individually via mechanical lock -Each
