Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Thu Nov 14 11:37:49 EST 2019 | tcpds
Do you still have the dek248 squeegee clamps/blades? please direct email me at thart@prairiedigital.com
Electronics Forum | Fri Feb 16 13:29:53 EST 2024 | mistrthou
We don't have that machine, but our other DEK's all share a solenoid. Air for both sides should be on or off all together. I'd check for an air supply to the clamps that switches when commanded to clamp or unload.
Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr
any one know the part# for the cable that clamp the stencil??
winsouce.jpg)
.gif)
