Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Fri Mar 26 23:07:07 EDT 2010 | dekhead
Just a guess: Are you printing your fiducials on the fiducial side of the board? Fidicial Side is for Vision Calibration, Bare Copper Side is for Offset Calibration (Step 5 of procedure says "copper side uppermost"). After printing 25 fiducials o
Electronics Forum | Fri Mar 26 21:48:56 EDT 2010 | dman97
Can someone explain to me what I'm supposed to do after I have done the vision offset calibration procedure? The manual tells me to put solder paste down on all 25 holes of the stencil. After this the board drops down and the machine scans each fidu
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Oct 15 09:04:06 EDT 2002 | sueph
Dear Pete, thanks for the reply. My calibration procedure says pretty much what you said: variance of 10 degrees F. I am having a temp. swing of close to 80 degrees F. and no matter how I try to situate the thermocouple back into the preheater, I ca
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Mon Apr 25 12:11:29 EDT 2005 | lyrtech
Hi, Does anyone know the rules to calibrate a feeder without any expensive jig test? We want to do that by our operators. Does anyone know the procedure? Thanks
Electronics Forum | Wed Oct 12 13:29:33 EDT 2016 | bobpan
Hello Todd, Go to my website: www.precision-repairs.com Send me an email from there and I will send you a document that has the calibration procedure in it. Bob