Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Tue Jul 02 15:13:13 EDT 2019 | daniel_marquette
On our QSP-2, the Y axis belts start to vibrate during the process so we need to open the doors to stop this because of the humming sound. What can creates this knowing that all the movements and placement are spot on?
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Mon Oct 14 11:56:02 EDT 2024 | poly
I just got a used SE500 Ultra and the machine appears to move in the X and Y, conveyor belts and width. It however fails to home. I assume the end sensor has physically moved or it's an issue with the Z axis. The logging says it's axis 0, however th
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Thu Jan 06 09:31:45 EST 2022 | hello112
Does anyone have the part number of the Y-axis belt for this model DEK HORIZON 03IX press?
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
