Electronics Forum | Wed Mar 26 16:10:13 EDT 2008 | kpm135
When was the last time your ELA was calibrated? I had an operator ding the camera some how and the machine acted very much as you describe afterwards. A camera calibration corrected the problem.
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Thu May 17 06:46:39 EDT 2018 | godless
After fresh install and loading only machinekey + stdeaf files it worked, thanks. But still there is camera problem which appeared from the beginning. I attached files where you can see error details. Software reinstallation not solved issue. Then ca
Electronics Forum | Tue Jul 13 14:03:33 EDT 1999 | Earl Moon
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Wed Sep 17 10:28:05 EDT 2014 | travishemen
We had a Dek 265 LT that had a similar issue. We suspected it was a bad cable going to the camera as the issue always seemed to show up in the same X Y location. Have you tried swapping fiducial 1 and 2 to see if it is always the first fiducial or
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Sat Jun 22 07:38:58 EDT 2019 | emanuel
We have a printer with Hawkeye 1700. The PCB side sometimes returns a distorted picture. It happens erratically, can be at startup or after a while, sometimes the machine works full day without problems. The only way to restore operation is disconnec
Electronics Forum | Fri Aug 09 14:38:56 EDT 2002 | burb1999
Any one using/used a DEK ELA? I have used the DEK 265GSX so just wondering differences (sure I could look it all up but...) now if I had a choice what would I want a used 265GSX or new ELA? I believe the camera on the ELA is better than the GSX and
