Electronics Forum | Thu Sep 25 09:56:23 EDT 2008 | mysmt
Hello, we are using DEK265gsx printers, at the minute ARCOM unit is not communicating with motor control cards 0,1,2,3 in Y1 enclosure. Checked CPU & RS232/485 cards from other DEK265, found okay. Any help will be appreciated. Mysmt
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Thu Sep 25 16:23:42 EDT 2008 | aj
Hi, Have you tried to download the MINT ?if this works you should be back in business , if not,check your PSU, which you can access from the back? check the manual as to which one powers the cards- dont have manual to hand but I think it is the 5v
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
winsouce.jpg)
.gif)
