Electronics Forum: dek clamp cables (Page 1 of 12)

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead

>> mis-alignment?

DEK265 GSX chase clamp error

Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas

problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas

correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...

DEK265 GSX chase clamp error

Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead

I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)

DEK265 GSX chase clamp error

Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas

sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking

DEK265 GSX chase clamp error

Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas

screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st

dek 265 LT screen printer unable to detect the plate

Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead

If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st

Dek Horizon

Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr

any one know the part# for the cable that clamp the stencil??

DEK Horizon 05

Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76

I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.

DEK Horizon 05

Electronics Forum | Fri Feb 16 17:04:17 EST 2024 | jborrelli76

Thanks, will do. The point that's odd is one side functions. I think there may be a cable that causes each bank to clamp that may be broken. Time to get my hands dirty...

  1 2 3 4 5 6 7 8 9 10 Next

dek clamp cables searches for Companies, Equipment, Machines, Suppliers & Information

consignment program

Have you found a solution to REDUCE DISPENSE REWORK? Your answer is here.
convection smt reflow ovens

Software for SMT placement & AOI - Free Download.
2024 Eptac IPC Certification Training Schedule

Best Reflow Oven