Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...
Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Sat Apr 17 17:45:52 EDT 2021 | silverlead
Hello SMTnet, Can anyone recommend a repair service for DEKs in the Midwest area?
Electronics Forum | Sun Apr 18 00:49:21 EDT 2021 | dekhead
I am based in TX but do service on DEKs nationwide. DEKHEAD@att.net
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st