Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Tue Jan 21 08:49:42 EST 2020 | emeto
I am sure you can upgrade it with DEK and it should not be so expensive. You can also ask them the price of the auto system. This is an arm(controlled by cylinder I think) and software to control it. This one moves the stencil in place when you load
Electronics Forum | Wed Dec 25 06:15:41 EST 2002 | hany_khoga
Hi There: We have a wavesolder m/c with foam fluxer. I want to know: - When we do not run the machine, how to keep the fluxer porous cylinder in a good condition? knowing that we use no-clean flux. Is it the same when we stop for a few days or wee
Electronics Forum | Tue Nov 07 10:16:20 EST 2006 | kevinp
The touch down sensor is probably the culprit, however make sure the head is not impacted with old solder paste and that the cylinders that flip the head are functional. I have had problems with one of the cylinders not functioning this caused the he
.gif)
winsouce.jpg)