Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Mon Sep 03 22:58:55 EDT 2001 | Poon Man
Hi Steve, Our China plant is using DEK 288. The cycle time is very impressive. However, there are some imperfections make our engineers feel bother. Maintenance is a big problem. As the machine was discontinued, the immature design was not improved.
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Thu Apr 20 13:55:31 EDT 2006 | cyber_wolf
Here is the problem : We have 2 AP25 printers with dedicated tooling. After we run side one boards through reflow, we get some warpage in our boards occasionally.(Sometimes we get a lot of warp depending on the geometries of the substrate) When the
Electronics Forum | Mon Feb 14 15:14:54 EST 2000 | dean
Dek 248 / 249 (mfg'95) MPM 2000 Realignment? Are you having to insert print offsets (X.Y, theta)? If yes, your vision cubes are out of alignment. This typically happens if a "crash" occures. A "C" tool can correct this. Or are we talking abou
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
Electronics Forum | Thu Dec 19 07:12:41 EST 2013 | bestglobalsmt
You don't say what software version is running on > machine; generally caused by corrupted file; > delete E: config local.lpf file and then reboot > machine (new file will be created). If not this, > recommend reload of machine software (should n
| 1 |
winsouce.jpg)
