Electronics Forum | Mon May 16 20:04:33 EDT 2022 | rob1
Thanks for the reply.
Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Thu Sep 29 03:40:43 EDT 2005 | aj
I have over 6 years experience working on Dek Printers, and I would highly recommend them to anyone BUT I have never seen the 2D Inspection last any longer than a couple of weeks running on the machine. This is the one side of things that they FAIL.
| 1 |
winsouce.jpg)
