Electronics Forum | Mon Aug 12 13:11:47 EDT 2002 | pjc
I am not a DEK user but have some knowledge of the ELA to share. The ELA has some structural differences with the Horizon and Infinity models. It is DEK's low-end automatic printer (a cost-reduced version of the Horizon model)and is manufactured in C
Electronics Forum | Fri Aug 09 14:38:56 EDT 2002 | burb1999
Any one using/used a DEK ELA? I have used the DEK 265GSX so just wondering differences (sure I could look it all up but...) now if I had a choice what would I want a used 265GSX or new ELA? I believe the camera on the ELA is better than the GSX and
Electronics Forum | Wed Mar 26 16:10:13 EDT 2008 | kpm135
When was the last time your ELA was calibrated? I had an operator ding the camera some how and the machine acted very much as you describe afterwards. A camera calibration corrected the problem.
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Tue Jul 30 12:30:21 EDT 2013 | JB
We are breaking a 1995 Dek 265GS screen printer for spares, it has the blue under screen cleaner, green 2D inspection camera. Was in full working order before getting a new Dek printer installed. The reason for replacing it was the air line pipes had
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
.gif)
