Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Mon Dec 08 17:06:54 EST 2008 | smellew
Hi Grid lock & others are ok solutions but i've tried them all the best system i received was from a company in eastern eu called cisoli ltd they supply support systems for DEK's MPM's and any placement machine i used them on DEK ELA Fuji CP642 & IP3
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Sun May 02 11:41:04 EDT 2010 | bruceb
My DEK 265GSX will not boot in the mornings. When I check my power supplies 5 volts is measuring 1.6v. When I disconnect 5v I read 5.3v on the power supply. When I reconnect to the power supply the problem goes away. Has anyone seen this problem and
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Fri May 21 08:11:54 EDT 2004 | Chunks
Check the surge protector on top of the power supply. Pretty common problem on the 265s.
Electronics Forum | Fri Nov 04 07:20:27 EST 2005 | chunks
By-pass the surge protector on top of the power supply. Located at the bottom of the machine. Pretty common on older 265s.
winsouce.jpg)
