Electronics Forum | Wed Jun 29 15:42:19 EDT 2011 | dekhead
Yes it is "Print Front Limit" and "Print Rear Limit". Negative value extends the stroke, Depends on software version how useful it will be, as there are differing limits on how much you can extend the stroke. http://www.dekhead.com
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Mon Jan 06 19:12:52 EST 2020 | dekhead
If you are unable to get to Diagnostics to exit to DOS; Try the following: ‘F5’ (WHILE STARTING MS-DOS) –OR ‘CTRL’ – ‘C’ (WHILE HIMEM IS TESTING EXTENDED MEMORY) Once in DOS, CDMINT Type LOAD to download MINTS from HDD to cards. DEKHEAD
Electronics Forum | Tue Jan 07 07:55:24 EST 2020 | dekhead
If it happened after holiday shutdown; good chance you have onboard battery going bad (battery dropped too low during extended shutdown). Replace batteries to alleviate future occurrence.
Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead
If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Wed May 31 10:39:33 EDT 2006 | grantp
Hi, We actually tried to get major parts of our line from the same supplier, however each supplier is good at some parts of the line, and not others. We went with Soltec oven and wave, which work well, and have not had any issues, plus DEK printer
Electronics Forum | Thu May 11 04:23:50 EDT 2000 | Earl Moon
Hey folks, I'm on your side, as I said many times in this string. To end it, from my point of view, I will offer the following diatribe with which I responded to one of you whom I respect very much - Dave F. This is my last say on the subject and I
Electronics Forum | Tue Jul 20 19:09:25 EDT 1999 | JohnW
| | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk pas
.gif)
