Electronics Forum | Thu Sep 18 07:26:57 EDT 2014 | mpolak
Hello, Have you tried using pads and apertures as fiducials using video model? Regards Marcin
Electronics Forum | Mon Mar 24 15:54:36 EDT 2008 | Paul M.
What r u using for fiducials ? fids? pads? thru-holes? video model? What r u using to print the paste? squeege blades? proflow? paste puck? Why r u using Step Mode ?
Electronics Forum | Tue Jan 30 14:18:22 EST 2024 | spoiltforchoice
It might be worth mentioning that Speedprint (now Europlacer) printers also have a calibrate using your own board capability. They arguably also target higher mix environments given that is the market the pick and place machine targets. DEK uses a v
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Wed Mar 27 02:36:27 EDT 2024 | dekhead
DEK 265LT was not mfg until 1995/6, verify model; what camera (4 possibilities on LT) is on machine? Have you verified / replaced video cable from camera all the way back to cognex?
Electronics Forum | Thu Oct 05 20:48:06 EDT 2006 | darby
We run Dek ELAs and MPM UP1500, Everyone here prefers the Deks. Set up, software, maintenance, operation etc. There's not a lot in it - the guys just prefer the Deks. However we are an OEM and so get control on board design, finish, fiducials etc. So
Electronics Forum | Mon Feb 17 02:51:21 EST 2003 | Scott B
We have also had this problem. I have managed to get around this by selecting a teach video model and positioning the teach window to include half the pad on the left and half the pad on the right so that the center point is bang in the middle of the
Electronics Forum | Thu Jun 23 15:28:48 EDT 2005 | geb
Yeah it says "board model not found", occasionally it will say "Stencil model not found" or something very similar. Do you have the exact same machine? It only shows a small live video image in the bottom of the screen (about 4cm sq.), I cant remembe
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
winsouce.jpg)
.gif)