Electronics Forum | Sat Feb 27 20:06:13 EST 2010 | jmelson
Oh, the CSM only has one XY offset for each feeder rail. If you don't like it, you can teach any particular feeder location. The crazy thing is the teach camera is an inch in front of the heads (-25 mm Y) so you can't put the teach camera over the
Electronics Forum | Sat Feb 27 00:59:43 EST 2010 | jmelson
Hi, I have a CSM84, PA1306/20. When I got it, a lot of the offsets had been zeroed out. I figured out a procedure to calibrate the back feeder rail, but haven't come up with a scheme to calibrate the mechanical alignment unit. I have it close, but
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
| 1 |
