Electronics Forum | Tue Sep 16 14:57:59 EDT 2014 | emeto
Board stopX and Y. Have you tried to run the board on 180 degreese? Or 90?
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Fri Aug 28 11:59:05 EDT 2015 | gascon5383
Actually I should have noted we resolved this issue. After chasing our tails for a while, we found that somehow there was a static charge on the boards going into the machine. This static was discharging to the camera through the board stop, causing
Electronics Forum | Tue Sep 16 13:43:48 EDT 2014 | gascon5383
We have new stencils produced every 15000 prints. Another technician takes care of that and he uses gerber files to have them produced. Also, we have over 300 different products that are produced, all board sizes are standardized 287mm long x either
Electronics Forum | Tue Sep 30 16:59:25 EDT 2025 | assuredtech
Sounds like you need to keep it simple and get back to the basics: Screen stretch, blade wear (swap blades front/rear and is if symptoms change), Board Clamp Foils, Board Support Tooling. Board DFM (especially related to Fid's), put a By-pass key in
Electronics Forum | Fri Aug 28 11:39:23 EDT 2015 | dlee87
I have an issue with this DEK printer our company > has been having for over a year now. It seems > that DEK can’t narrow down what the issue > actually is as well. The printer is a DEK Horizon > 03i 09 SP13 P02. We are having an issue with
Electronics Forum | Mon Sep 15 10:22:45 EDT 2014 | island2013
Sounds like all the usual suspects have been replaced. How about some completely random thoughts. For this specific product, you mention it runs a few boards then fails out. Does it fail out on one specific fiducial on this product every time or i
Electronics Forum | Sat Sep 06 07:20:37 EDT 2014 | gascon5383
I have an issue with this DEK printer our company has been having for over a year now. It seems that DEK can’t narrow down what the issue actually is as well. The printer is a DEK Horizon 03i 09 SP13 P02. We are having an issue with the camera.
Electronics Forum | Tue Sep 16 09:39:33 EDT 2014 | emeto
Hi there, It looks weird how you handled the problem. Just a thought, but would you check the stencil and may be recut a new one, making sure you have the image exactly in the center and have the fiducials exactly where you want them and the frame
Electronics Forum | Tue Nov 04 20:23:16 EST 2025 | alansyncron
Ive had this happen on an older horizon. Our issue was a missing tooth on a belt. It would get worse until a stencil wipe. That would "reset" the belt until we hit the missing tooth again. I assume its set to wipe every 4th board?
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
