Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Wed Feb 14 23:56:06 EST 2024 | jborrelli76
We have a DEK Horizon 05 with stencil clamps operational on left side only, right side non-opertional. Any ideas where to get started troubleshooting?
Electronics Forum | Fri Feb 16 13:29:53 EST 2024 | mistrthou
We don't have that machine, but our other DEK's all share a solenoid. Air for both sides should be on or off all together. I'd check for an air supply to the clamps that switches when commanded to clamp or unload.
Electronics Forum | Fri Feb 16 17:04:17 EST 2024 | jborrelli76
Thanks, will do. The point that's odd is one side functions. I think there may be a cable that causes each bank to clamp that may be broken. Time to get my hands dirty...
Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76
I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.
Electronics Forum | Thu Feb 29 04:26:27 EST 2024 | jborrelli76
A spare part due very soon, now to change it out. I think I have to remove the entire right arm...suggestions or guidance WELCOME. Thanks!
Electronics Forum | Mon Feb 19 12:45:30 EST 2024 | davef
Search for 163368 on SMTnet. Look in the list further down on this page https://smtnet.com/parts/index.cfm?fuseaction=view_item&item_id=165987&company_id=54555 Contact Qinyi Electronics Co., Ltd and ask for Cosima (
Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d
Electronics Forum | Wed May 31 07:59:47 EDT 2017 | buckcho
Or if you have 2010 Dek, you can get the paste height monitoring system, which is pretty cool. I used it and for Lead free paste is great. Combined with the dispensing system I made my operators very lazy :)
