Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Wed Dec 13 14:33:06 EST 2023 | carl_p
I would start by checking the caps on the PC board. I used to have the same machine & they would fail every few years which could cause some random errors to appear on times.
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Fri Feb 16 13:29:53 EST 2024 | mistrthou
We don't have that machine, but our other DEK's all share a solenoid. Air for both sides should be on or off all together. I'd check for an air supply to the clamps that switches when commanded to clamp or unload.
Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr
any one know the part# for the cable that clamp the stencil??
Electronics Forum | Wed Feb 14 23:56:06 EST 2024 | jborrelli76
We have a DEK Horizon 05 with stencil clamps operational on left side only, right side non-opertional. Any ideas where to get started troubleshooting?
Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Mon May 05 08:42:35 EDT 2008 | mmjm_1099
We use double image stencils with our DEK Horizons. My operators would just load the pcb on to the rials and manually adjust the stencil and clamp it. Once they do that they add into the comments what number the handcrank adjustable is at so next tim
Electronics Forum | Tue Jan 30 15:12:56 EST 2024 | oxygensmd
We have 3 of them. E5 (2000), X5 (2006), X4 Proffessional (2012). All of them can handle our requirements, even E5 have the requested accuracy. X5 have disk PCB clamping which really nice for the operators and X4Prof have SPS (3-stage) witch pneumati
Electronics Forum | Fri Feb 16 17:04:17 EST 2024 | jborrelli76
Thanks, will do. The point that's odd is one side functions. I think there may be a cable that causes each bank to clamp that may be broken. Time to get my hands dirty...
