Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Tue Jun 03 18:49:32 EDT 2008 | edgetech
Hey, Does anyone have a calibration procedure for this machine. Thanks!
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Wed Nov 06 06:46:27 EST 2019 | wippsen
Machine Calibration --> Pressure
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Wed Nov 06 07:27:47 EST 2019 | kylehunter
To do that requires a calibration scale, which we don't have. But even if it is out of calibration, it still wouldn't explain why it states that the setpoint is 5kg always, even when it is set to 12kg.
Electronics Forum | Sat Nov 09 20:16:01 EST 2019 | richardcargill
No problem. I'll get a picture of our calibration setup for you too, give you an idea of how to do it for a couple of bucks instead of getting the official calibration jigs !!
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
Electronics Forum | Wed Nov 06 08:23:53 EST 2019 | dekhead
If it is always showing 5.0Kg as the "target" value on the error on the first print then yes there is a problem. Are you certain that it is accomplishing the requested (12Kg ?) on the prints thereafter? Does it do Heights calibration (no tools requir
Electronics Forum | Sun Nov 10 04:24:01 EST 2019 | richardcargill
Not disagreeable at all. You're correct that I was referring to a Mk1, and in this instance it's hard to trust the display without ensuring the calibration is right
winsouce.jpg)