Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Fri Oct 02 21:40:49 EDT 2015 | gafur
hi all...please give me advice..my machine dek horizon 03ix error can node machine I/O...thank's before...
Electronics Forum | Tue Jan 21 08:49:42 EST 2020 | emeto
I am sure you can upgrade it with DEK and it should not be so expensive. You can also ask them the price of the auto system. This is an arm(controlled by cylinder I think) and software to control it. This one moves the stencil in place when you load
Electronics Forum | Thu Aug 27 09:29:04 EDT 2020 | serge_pirog
Yes, I calibrated the height, no error. How can I check that pressure was compensated? If we press button "continue" after some cycles of printing system will show "error".
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Mon Oct 03 09:19:10 EDT 2005 | John S.
We've been using Horizon 01's for a couple of years. We use the advanced 2d board and stencil to setup process control through QC-Calc. It works very well, but you must put the time into setting it up. Ask DEK if they can get you a manual for thei
Electronics Forum | Fri Aug 28 11:39:23 EDT 2015 | dlee87
I have an issue with this DEK printer our company > has been having for over a year now. It seems > that DEK can’t narrow down what the issue > actually is as well. The printer is a DEK Horizon > 03i 09 SP13 P02. We are having an issue with
Electronics Forum | Sat Sep 06 07:20:37 EDT 2014 | gascon5383
I have an issue with this DEK printer our company has been having for over a year now. It seems that DEK can’t narrow down what the issue actually is as well. The printer is a DEK Horizon 03i 09 SP13 P02. We are having an issue with the camera.
