Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Tue Jun 05 16:12:51 EDT 2012 | kahrpr
We use both The pin placement works fine for the mpm. If its a dense board you have to to some double checking on the initial set up. On the dek we use Grid lock. For us its toss up which is better they both work.
Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Fri Jun 22 20:46:10 EDT 2007 | nickh
I ran into an error with our DEK 288 machine, when I go to initialize the machine the following error occurs: Squeegee Height: Error Input Active. This occurs with or without a squeegee present, and I have tried restarting multiple times, but the sa
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 09 19:35:09 EST 2023 | youngbuck
Hello, We have a Dek Infinity when powering up will not initialize due to an error that says Rising Table Error (Position Error). I try to go to Diagnostics but it will not let me into anything. I press start when I'm in diagnostics and it just error
Electronics Forum | Tue Jan 09 14:41:55 EST 2018 | bsyeo
Hi All, Need some help on this. We have a strange problem with our Dek API. There is no camera vision but everything is able to initialize well. The vision works occassionally but most of the time it does not. We have checked the nextmove card, int
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
