Electronics Forum | Wed Jun 26 17:46:48 EDT 2013 | dman97
numeric values are input by pressing the / key.
Electronics Forum | Tue Aug 13 13:47:58 EDT 2002 | cnoonan
To Everyone, Does anyone need someone that has process engineering, programming and/or experience maintaining SMT&PTH equipment? Send me an email and I will forward you my resume... I have worked with Fuji, Universal & Siemens pick and place as
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Thu Dec 15 01:21:42 EST 2005 | bvdb
We own a Fuji IP1 with all the manuals, etc. but can't figure out how to inch the tray robot. We can inch the X, Y, Z, Q axis and the SX and SY axis. All the axis auto zero OK (including the trays), but when I push the "4" key to inch the trays we
Electronics Forum | Fri Jan 18 21:13:51 EST 2013 | ngineer
I was trying to set up a new board, and after creating the board directory, the CC spit back a line of garbage and said the directory was invalid. I pressed escape to start over, and it froze. Now when i start it every time, it goes through login a
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Wed Feb 15 10:21:54 EST 2012 | caerleon
You can buy the kit from DEK direct and it contains self assembly instructions, changed ours in under 15 mins - no need to send it back for repair. Key for durability, is using the correct pressure!!!
