Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Fri Feb 16 13:29:53 EST 2024 | mistrthou
We don't have that machine, but our other DEK's all share a solenoid. Air for both sides should be on or off all together. I'd check for an air supply to the clamps that switches when commanded to clamp or unload.
Electronics Forum | Thu Nov 15 12:07:08 EST 2001 | mgillespie
Although this is a old message, I would like to add that DEK do offer a edge clamping option on ALL 265 class machines, thereby removing those sharp edges from the machine. Regards Mark.
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
Electronics Forum | Mon Oct 09 14:30:44 EDT 2006 | Brian
I agree with Chunks. Programming was much simpler. The 2D inspection is much better on MPM. I didn't have to use offsets on the MPM or the DEK very often, but did more on teh DEK. I didn't like the front justified stencils on the DEK. I also did
Electronics Forum | Mon Sep 03 22:58:55 EDT 2001 | Poon Man
Hi Steve, Our China plant is using DEK 288. The cycle time is very impressive. However, there are some imperfections make our engineers feel bother. Maintenance is a big problem. As the machine was discontinued, the immature design was not improved.
Electronics Forum | Tue Sep 29 01:51:37 EDT 1998 | Earl Moon
| I'm going to purchase a screen printer. | I've looked at the SMTech/Sigma 500 (also called Quad AVX500). | Has anyone any comments to this machine or production experience? | Anything would be appreciated. | I'ld like to hear any other type of ma