Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 09:43:31 EST 2018 | dekhead
Sorry, you said LT... correct dwg. On LT (assuming not very early software version), you can discount that sensor by selecting "Center Justified" for screen image...
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
Electronics Forum | Tue Nov 20 21:13:32 EST 2018 | sabeti
Hi there, I have found another sensor and replaced it but the display still shows as "Insert Screen and Retry". Do you know what the issue would be? Thanks
Electronics Forum | Wed Nov 21 09:10:11 EST 2018 | dekhead
Are you seeing the stencil operational (changing state) in diagnostics? If sensor works then, look at image justification in product file...
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Fri Apr 29 22:35:01 EDT 2016 | dekhead
Pneumatic failure is a good guess, as GSX/LT are renowned for their leaky airlines. However on this I would doubt, since the Board stop is a single throw pneumatic with a spring to retract. The return spring broken / disconnected is certainly a possi
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
