Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Wed Aug 20 10:16:58 EDT 2008 | dekhead
248 Table In/Out is pneumatic (as stated), but I think Shane is referring to Print Carriage which is electrical with positional "encoder" feedback. Need to check for feedback display in output dignostic.
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Mon Feb 04 22:29:55 EST 2013 | armandogomez
This is a very common question, I can relate to your question I have here almost the same setup on the smt line, printer a DEK, MY12 and an awful versatronics oven, about the question about the responsibilities, here the operator has only the knowled
Electronics Forum | Mon Feb 12 21:38:38 EST 2007 | DEK Answer Guy (PR Dept)
Technical Papers) -ProFlow� upgrades (MPU's). -Paste Low Optimisation -Adjustment of the Print Carriage to ensure Squareness to the Stencil -Replacement of Hinge Pin Assembly -Conversion of ProFlow� to Horizontal Mount -ProFlow� Guides for Operators
Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Tue Oct 31 13:15:13 EST 2006 | realchunks
SWAG is prolly right. You can verify the tactile sensor by watching the machine carefully. When finding the stencil height, make sure the board goes all the way up and touches the stencil to trigger the tactile. If it doesn't, then something is wr
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
| 1 |
winsouce.jpg)