Electronics Forum | Thu Mar 30 10:54:48 EDT 2017 | emeto
If you use the calibration plate and stencil, that should fix the problem. I think that you are not saving the result from the calibration test. Double check manuals and probably with DEK technician, but it sounds like you are missing a step.
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Thu Apr 01 18:13:19 EDT 2010 | dman97
Since my last post, I have successfully calibrated my printer. Now I have noticed that after a print, the machine decides to check for fiducials again. A post print fiducial check. Do you know how to disable this? It is slowing down my process co
Electronics Forum | Tue Nov 20 09:22:15 EST 2018 | dekhead
Maybe info you need?
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 09:43:31 EST 2018 | dekhead
Sorry, you said LT... correct dwg. On LT (assuming not very early software version), you can discount that sensor by selecting "Center Justified" for screen image...
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
