Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Nov 20 09:22:15 EST 2018 | dekhead
Maybe info you need?
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 09:43:31 EST 2018 | dekhead
Sorry, you said LT... correct dwg. On LT (assuming not very early software version), you can discount that sensor by selecting "Center Justified" for screen image...
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
