Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Thu Apr 29 14:41:12 EDT 2004 | pjc
OK if the paper is transparent and you can adjust the table X-Y-Theta under the paper- without moving the paper - the align with the solder lands on the board. If you have a DEK or MPM machine, the Mylar frame is like $300. I belive other printer mfr
Electronics Forum | Wed Feb 14 08:48:57 EST 2024 | andrii
hi, I have very very old DEK 265 Lt And I have a problem that Mr. processman described a long time ago. But no one answered him. Maybe someone can help me now? "We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LE
Electronics Forum | Mon Feb 24 12:14:07 EST 2003 | gilligan
We use an EKRA E4 printer, but the concept sounds the same as far as the fiducial alignment goes. I have found that SOT-23 components work the best for fiducials - and I always make it a point to use them on our older PCB's (where the screens do not
Electronics Forum | Thu Apr 01 18:13:19 EDT 2010 | dman97
Since my last post, I have successfully calibrated my printer. Now I have noticed that after a print, the machine decides to check for fiducials again. A post print fiducial check. Do you know how to disable this? It is slowing down my process co
Electronics Forum | Wed Feb 13 21:07:26 EST 2019 | sabeti
Hi Everybody, Appreciate if someone could help me with the above issue. Regards
Electronics Forum | Thu Feb 14 00:43:27 EST 2019 | dekhead
I sent PM to your email.
Electronics Forum | Thu Mar 04 08:49:12 EST 2004 | ianlg
Hi Kistech is a UK based company. The MD is a David Wheatley who was one of the founders of SMTech Ltd who designed and manufactured the 100MV prior to the company being purchased by MPM. The microflex is a re-engineerd version of this machine. The
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Feb 12 01:14:46 EST 2019 | sabeti
Hello Everybody, I have a problem with a DEK 265Lt, during downloading the vision, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broke
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
