Electronics Forum | Thu Jun 16 20:29:12 EDT 2011 | dman97
Does anyone know if it is possible to change the distance that the squeegees travel? What i mean is... Is it possible to change where the squeegees start and stop during a print? Our squegees seem to stop right at the edge of the apertures and this
Electronics Forum | Wed Mar 27 16:54:47 EST 2002 | davef
STARTING RANGES * Pressure � 1 pound/inch of blade (metal); 1.6-3 pound/inch (plastic) * Speed - 0.5 to 3 inch per sec [for standard pitch]; 0.5 to 1 inch per sec [for fine pitch] Your paste supplier�s recommendation is a good place to start. * Sepa
Electronics Forum | Thu Dec 16 15:00:20 EST 2004 | glaucon
Simple differences. Both processes require a very similar machine platform, controlled motion, vision fiducial recognition and alignment of a substrate (PCB or hybrid ceramic) to the "image", the image being either a stencil (hence stencil printing)
Electronics Forum | Fri Jan 22 11:24:10 EST 2010 | thanh
HAVING A PROBLEM WITH DEK-248 REAR SQUEEGEES AFTER PRINT NOT COMING BACK UP. AFTER SHUT DOWN TO REBOOT, BOTH DROP DOWN,INITIALIZE MACHINE THE FRONT WORK NORMAL, THE REAR SLOWLY MOVING BACK UP, ANY ADVISE. THANKS
Electronics Forum | Mon Feb 04 22:29:55 EST 2013 | armandogomez
This is a very common question, I can relate to your question I have here almost the same setup on the smt line, printer a DEK, MY12 and an awful versatronics oven, about the question about the responsibilities, here the operator has only the knowled
Electronics Forum | Fri Oct 11 03:06:00 EDT 2019 | bukas
Hello Dekhead, it is a constant offset, like 0.5 mm to right when machine prints away from operator. When print goes towards the operator there is no offset. I swapped X5 and X6 cards with spares I got but still same result . I set the program to hav
Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Fri Dec 28 17:44:41 EST 2007 | flipit
Back in the mid 90s I used an SVS 3D solder paste inspection system. We used it as a stand along unit but it was an inline model. We would bring printed PCBs off the Dek 265 solder printers and check every 5 or 10 printed panels. They almost alway
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
Electronics Forum | Sun Mar 07 08:02:40 EST 1999 | Earl Moon
| My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The v
