Electronics Forum | Thu Dec 30 16:10:37 EST 2010 | ev
Seasons Greetings to all. Here's hoping for a great 2011. I have a Mydata TP11-UFP that won't initialize on start up. Hence we can't run production. Has anyone seen this problem? Do you have any suggestions.
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Fri Jul 25 10:11:36 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Fri Jul 25 10:13:01 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Wed Sep 12 08:22:52 EDT 2001 | pr
Last I heard DEK was coming out with a new Revision of Form Flex to address some of the problems seen on the old revs. You should contact Dek and see if they will replace your old ones with the new rev. When ot works it's a great tool.
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
