Electronics Forum | Fri Feb 29 09:56:34 EST 2008 | iantech
Hi all are any of you guys using Dek proflow catriges with senju paste, Just wondering what the temp should be for transport and storage ian
Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Thu Aug 17 09:06:26 EDT 2000 | Chad
We are currnetly looking at switching form squeegee's to the Dek ProFlow head system. Just looking for feedback on the performance compared to squeegee's. Also here the ProFlow reduces the amount of waste of solder paste. Can anyone reflect on these
Electronics Forum | Wed Aug 15 16:25:52 EDT 2018 | ceharperc1
Anyone with a lot of printing experience, especially in proflow process? I am seeing a lot of voids in the bottom of the head after running. Will run with multiple good assemblies with paste volume being between 60% and 150%, out of no where we wil
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Tue Aug 22 11:25:43 EDT 2000 | Steve Thomas
Just out of curiosity, what's the maximum length print the Pro Flo is capable of? I think the Cross Flow option for the EKRAs that we use only goes up to 350mm, which is way short of what we'd need.
Electronics Forum | Fri Aug 18 13:38:09 EDT 2000 | James
I've heard there might be some problems when using an enclosed print head with water soluble paste. It dries out and compacts in the head. Just the opposite of what is claimed I know, but I hear it is wonderful when using no clean paste. Can anyon
Electronics Forum | Tue Aug 22 12:14:21 EDT 2000 | Tekguy2000
There are concretions that form inside the chamber when using a water soluble paste. They start forming and affecting print as early as 2 days. This is apparent no matter what type of print head you may be using. There has been over 30 water soluble
