Electronics Forum | Tue Nov 19 12:36:01 EST 2013 | youngbuck
DEK Infinity-Does anyone have any information on why the automatic screen changer would load the same screen in a different position everytime you load and unload? We constantly have to do a search step for the fiducial and most of the time it will e
Electronics Forum | Tue Apr 27 16:42:18 EDT 2010 | m79d
Hi jepoy + a very frazzled man thanks for your suggestions,here is how it went:- I found a couple of these VM1710 boards and tried one and still nothing. I really wanted to see if power was getting to the camera and anything coming out. I was loo
Electronics Forum | Sat Jun 21 11:00:32 EDT 2008 | 1036
We recently bought an used MPM SPM screen printer. The system can not boot up correctly and terminates the program finally. During the computer booting up, I can see error massages "mouse could not be found", "abnormal program terminated", "trap 0".
Electronics Forum | Mon Mar 06 17:42:18 EST 2017 | jswatt
Hey folks, looking for some thoughts on an error we are getting with a DEK Photon screen printer where the machine switches on and we get a DEK_CSS message - Dongle Not Found. Please connect a valid Dongle & restart the machine. the machine was work
Electronics Forum | Mon Feb 24 12:14:07 EST 2003 | gilligan
We use an EKRA E4 printer, but the concept sounds the same as far as the fiducial alignment goes. I have found that SOT-23 components work the best for fiducials - and I always make it a point to use them on our older PCB's (where the screens do not
Electronics Forum | Thu Jun 23 14:34:17 EDT 2005 | pr
Is it only this 1 job? Is the error "board model not found"? I have had instances where I taught the Fids. and it still didn't like them in production. Is the board fid. in the center of the screen when you try to run the job?
Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Wed Oct 10 17:47:49 EDT 2007 | jmelson
Does it give any more info about the error? Is this in the stage after you've hit run, it says "initializing" and it is counting up on the screen? Usually it gives a little more info, although it can still be cryptic. I have run into it stopping w
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
| 1 |
winsouce.jpg)