Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Thu Dec 09 04:11:54 EST 2021 | cirsol
Hello Forumers, I'm hoping there might be a SiPlace expert or two trawling the forum. We have an S25 machine that essentially has a failed MC harddrive and we're trying to rebuild a new one. Attached are a few images and perhaps something shown her
