Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Tue Jan 07 07:55:24 EST 2020 | dekhead
If it happened after holiday shutdown; good chance you have onboard battery going bad (battery dropped too low during extended shutdown). Replace batteries to alleviate future occurrence.
Electronics Forum | Tue Jun 03 18:49:32 EDT 2008 | edgetech
Hey, Does anyone have a calibration procedure for this machine. Thanks!
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Fri Nov 04 11:09:46 EST 2005 | moonshine
I concur with other advice. Visit http://www.moonmanondarkside.com for much more information and free operational procedures, from the POD ftp site, for this venerable machine. MoonMan
Electronics Forum | Fri Sep 07 17:13:54 EDT 2012 | burb1999
Run the calibration screen/procedure. I have had where the camera was hit etc.. and caused a misalligned print.
Electronics Forum | Wed Oct 12 13:55:14 EDT 2016 | dekhead
OLD DEK manuals actually have a procedure for fiducial fill, and they used to sell a kit (for way too much $$$$); since usually pretty well covered by stencil vendors probably not on the list any more. www.dekhead.com
Electronics Forum | Tue Mar 29 14:43:50 EDT 2022 | padawanlinuxero
Hi! Looks likely you have a calibration problem with the vision system, since is a 265 if possible try to restore a backup on floppy if not rerun the calibration procedure
Electronics Forum | Fri Jan 23 18:03:06 EST 1998 | Steve Gregory
Paul, I've got a third-level ISO Stencil Specification procedure that I did at a past employer that I'll send you...it also deals with the DEK-265 printer (which is what we used) when I talk about frame sizes and image positioning, but you can edit i
Electronics Forum | Mon Jun 03 16:52:22 EDT 2013 | smellew
Hi Yes, there is an FCU calibration procedure which may help you, for this information please contact us direct. Email llew@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com Fuji, DEK, BTU, Ersa & Vi Technical support & service