Electronics Forum: dek system power down error (Page 1 of 3)

DEK 265 pneumatic power down error

Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf

Good Day Sir. Where is the MMX?

DEK 265 pneumatic power down error

Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead

Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /

DEK 265 pneumatic power down error

Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk

We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p

DEK 265 pneumatic power down error

Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead

MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).

DEK 248 squeegee error

Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms

Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with

DEK 265 Horizon Servo Following Error

Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu

John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN

Dek Horizon Error

Electronics Forum | Wed Nov 29 05:59:09 EST 2023 | leeg

We have just powered the printer on and get the following error? Anyone seen this before? DEK_CSS Service check. Timed out. Check your system configuration and restart.

DEK 265GSX Rail System Error

Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta

We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian

DEK 265GSX HOOD OPEN ERROR

Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead

"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int

Dek-265

Electronics Forum | Tue Sep 11 09:08:17 EDT 2007 | gemengr

Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.

  1 2 3 Next

dek system power down error searches for Companies, Equipment, Machines, Suppliers & Information