Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jul 25 14:44:34 EDT 2013 | falvarez
Im needing an Rising table motor for Dek Horizon, but with a 4000 count encoder, because that motor i bought become with a 1000 count encoder and not worked. any suggestion?
Electronics Forum | Sat Oct 08 17:47:33 EDT 2016 | goldentech
Dek 248.cerd tooling table stuck in the up position,any one can help. Thanks, Tom
Electronics Forum | Sat Feb 11 02:50:07 EST 2023 | dekhead
Please contact me directly; DEKHEAD@ATT.NET
Electronics Forum | Tue Feb 14 05:01:29 EST 2023 | leeg
Sounds like the brake may have gone?
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Tue Sep 19 15:15:42 EDT 2006 | bigdaddysoy9
Have you tried changing the motor?
