Electronics Forum | Mon Dec 13 11:21:41 EST 2004 | wikunkle
To us the system seems very good. Mount & dismount is simple and solid. As a stencil supplier, we know there is another system that solves the sharp edge issue, called Wizard/QTS. DEK likely has the edge in a high prod. environment. Bill
Electronics Forum | Sun Dec 12 13:29:40 EST 2004 | stuart
HI , We have been evaluating this remountable foil system with a view to replacing our existing one. We don't have space for framed stencils but production are complaining about the sharp foils. There's not much in the archives on it but it seems
Electronics Forum | Wed Dec 15 20:17:48 EST 2004 | cmiller
We have switched from IIT pro-plates to QTS stencils. lots of companies provide them. We still buy from IIT, they have been one of the best suppliers we have had. The single axes tightening just does not get it anymore with the super small parts we h
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Thu Feb 12 11:41:21 EST 2004 | dblack
Steve, I would suggest you goto our website http://www.dek.com and contact your local stencils office who will be able to help with your requirements. Regards Doug
Electronics Forum | Sat May 29 22:10:28 EDT 1999 | Earl Moon
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Thu Apr 22 17:39:26 EDT 1999 | Earl Moon
| To all who will be potentially my salvation, | | I am currently researching Polyimide stencils for possible use and manufacture. If I may be indulged - with due reference to all past enquiries and notes on the subject - can anyone offer an up to d
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue Nov 20 19:09:04 EST 2018 | dekhead
Island SMT showing in stock. http://islandsmt.com/product/front-and-back-stencil-sensor
Electronics Forum | Wed Nov 21 09:10:11 EST 2018 | dekhead
Are you seeing the stencil operational (changing state) in diagnostics? If sensor works then, look at image justification in product file...
.gif)
winsouce.jpg)
